이 에피소드에 관해
Episode two digs into presets to boost throughput in CAM. Justin and Zap break down the golden rule—if you're dialing in feeds and speeds every single program, you need a preset—plus how far the rabbit hole goes with floor finishing, wall finishing, tape-and-glue, and everything in between. Plus why the same carbide in a different holder isn't the same tool at all.Check out Zap's IG @zap.consulting-----------------------------------------Help support the podcast www.patreon.com/withintolerancepodcast
영어
미국
전사 🔗
Are you the producer of this podcast?
Add a podcast transcript
Need Audio-to-Text?
Transcribe with Listen411 in Just 60 Seconds
이 팟캐스트의 다른 에피소드
Two months of catching up with Zap: the Toolpath Summit recap, his Claude-built ERP CritLink processing real money, and his Boise shop dialed in for remote operation. Dylan finally has power, runs the Flex overnight, untangles a kinematic shift on the C250, and survives a titanium job that tried to…
Kicking off Down the Rabbit Hole, a new Within Tolerance podcast for nerds, by nerds. Justin and Zap launch their multi-part series "My Tool Library Is Better Than Yours" with the bootstrap basics: a simple four-folder structure, modeling your holders and tools accurately, and getting rou…
Justin and Zap dig into the idea that a good tool library is never finished. They cover treating it as a digital twin of your crib, promoting tools from bench to standard, and when it's fine to let a specialty tool live outside the system entirely. The theme running underneath it all: seek perfecti…
Justin Gray catches us up on life post-Toolpath. We get into Justin Gray Labs and his vibe coding kits — along with the security nightmares they're built to prevent. He's also chasing fidget pistons to a two-tenth window on a Syil and Speedio. Then we get into Kinematic Sauce, the calibration algor…
면책 조항: 이 페이지에 포함된 팟캐스트와 작품은 Within Tolerance에서 가져온 것입니다. 이 팟캐스트는 소유자의 재산이며 Listen Notes, Inc.와 제휴하거나 보증하지 않습니다.
