इस एपिसोड के बारे में
An unvented cylinder can be fitted perfectly, look fine, and still fail three weeks later if it was never actually pressure tested. In this episode of The Copper Connection Podcast, Chris Bailey opens Unit 310 of the 9289 apprenticeship (ST0303), Phase 3, Learning Outcome 2, moving commissioning and handover thinking from cold water systems across to hot water systems.
This is Part 1 of a two-part hot water systems masterclass, covering the difference between open-vented and unvented systems, the full nine-step commissioning procedure, and steps two to four in detail: the visual inspection, filling and venting, and the soundness test. Chris breaks down where the 1.5-times test pressure figure in the Water Supply (Water Fittings) Regulations 1999 comes from, and how BS EN 806 can push that figure even higher — working through the bar-pressure calculations examiners expect for hot water safety and plumbing exam preparation.
You will learn to:
Understand the difference between open-vented and unvented hot water systems
Explain the full nine-step commissioning procedure for hot water systems and components
Identify the ten checks carried out during the visual inspection stage
Apply the correct filling and venting sequence for open-vented and unvented systems
Calculate the statutory soundness test pressure under the Water Fittings Regulations
Compare that figure with the BS EN 806 commissioning test pressure calculation
Explain the WRAS G12.2 and R12.2 requirements for testing rigid pipework
Identify the Test A and Test B procedures for plastic pipework under BS EN 806 Part 2
Grab your Unit 310 notes and work the bar-pressure calculation yourself before Part 2 lands with steps five through nine.
soundness testing, hot water systems, unit 310 phase 3, 9289 apprenticeship, ST0303
Hosted on Acast. See acast.com/privacy for more information.
